kitagawa

Language

Robot hand

2-jaw parallel gripper NPGT series

Thin 2-jaw parallel gripper

NPGT seriesズーム

NPGT series

  • Sophisticated and high-performance design achieves up to 40% thinner and 50% lighter.
  • High repeatability achieved through experience gained from chuck manufacturing
  • Achieves approximately double the gripping force of the equivalent stroke standard model
  • Equipped with high coolant resistance and lubricity obtained from many years of experience in chuck and NC rotary table manufacturing
  • Variety of options including three detection methods and the model with through holes (NPGT10)

How to order

NPGT series
  • Please install a check valve in the air-pressure circuit so that the gripper will not release a workpiece even if the air pressure drops down.

  • The length measuring sensor is a factory-installed option. Since optional parts such as cables vary depending on the signal output format, please contact the Kitagawa distributor when ordering the gripper with length measuring sensors.

  • When the jaw stroke is detected by the reed switches, mount reed switched on the grooves on the outer periphery of the product.

  • In case proximity switches are used for direct detection of jaw stroke, please purchase proximity switch brackets additionally.

  • The material of internal seals of grippers is nitrile rubber. If the fluororubber seals are needed, please consult Kitagawa distributor.

Specifications

ModelJaw stroke
in diameter (mm)
Gripping force(Note 1)Mass
(kg)
Body thickness (mm)Air pressure
(MPa)
Operating temperature
(℃)
OD gripping (N)
NPGT08(S) 16.6 720 0.79 36 0.2~0.8 5~60
NPGT10(S) 20.8 1160 1.25 41 0.2~0.8 5~60

Note 1: Value at air pressure 0.6MPa

Option

Drawing download

Model Drawing download
NPGT08 PDF DXF 3D
NPGT08S PDF DXF 3D
NPGT10 PDF DXF 3D
NPGT10S PDF DXF 3D

Machine Tool product lineup

PAGE TOP